Garland Concrete Lifting
Driveway Leveling in Garland, TX
Driveway leveling in Garland, TX fixes tilted or sunken sections with foam or slurry injection. Drive-safe results, free estimates.
- 15+ Years local experience
- 500+ Projects completed
- Licensed & Insured
Serving Garland and nearby communities.
Why is your driveway sinking on one side? Usually it's clay soil swelling under one edge while the other side stays put. That tilts the whole slab over time.
Driveways cover more surface area than a sidewalk or patio panel. Garland Concrete Lifting checks the full length section by section instead of treating it as one flat problem. More slab means more soil variation underneath it, so longer driveways on bigger lots tend to settle unevenly.
What's included
What's Included with Driveway Leveling
- Section-by-section evaluation — checking elevation across the entire driveway, not just the obvious low spot.
- Injection along low areas — material placed at each identified drop point.
- Vehicle-load consideration — injection pattern set to handle daily car and truck weight.
- Final grade check — full driveway re-measured for a consistent surface.
- Optional — sealcoat application after the concrete cures.
- Customer prep — move vehicles off the driveway for the full visit.
Want a clearer scope?
Get a Free EstimateHow it works
How Our Driveway Leveling Process Works
Step 1Full-length inspection
Every section checked for drop and tilt.
Step 2Mark injection points
Low spots flagged along the driveway's length.
Step 3Drill access holes
Holes placed at each marked point.
Step 4Inject foam or slurry
Material choice matched to slab thickness and age.
Step 5Recheck grade
Driveway re-measured end to end.
Step 6Patch holes
Access points filled and smoothed.
Materials
Materials and Methods for Driveway Leveling
Driveway slabs vary a lot. Older pours run thinner. Newer builds run wider and thicker. Material choice comes down to what's underneath, not the year the slab went in.
Polyurethane foam injection
lightweight and fast-curing, a good fit for thinner slabs common in older neighborhoods.
Cement-based mudjacking slurry
heavier and better suited to larger, thicker slabs where the void underneath is bigger.
Hydraulic cement edge patch
used to seal drilled access points and reinforce slab edges after the lift.
Questions on materials?
Get a Free EstimateBefore & after
Before and After Driveway Leveling
Before 
After
FAQs
Driveway Leveling FAQs
Why is my driveway sinking on one side?
Usually because the clay soil under one edge shrank or shifted more than the soil under the rest of the slab, leaving a void that lets that side drop.
How soon can I drive on my driveway after it's lifted?
Foam-lifted sections are typically drivable the same day. If mudjacking slurry was used on a larger section, plan on waiting until the next day for full vehicle weight.
Can a leveled driveway tilt again later?
It can if the soil underneath keeps moving, which is common with Dallas County clay. A properly filled void resists it far better than doing nothing.
Does foam injection smell or leave a mess on my driveway?
No strong lingering smell, and the process is dry, no slurry runoff to clean up afterward like older mudjacking methods sometimes leave.
Next step
Get a Driveway Leveling Estimate in Garland
Call Garland Concrete Lifting or request a free estimate. We'll walk the full driveway before quoting anything.
Related: Mudjacking · Home
---
More services
Other Concrete Lifting services
Concrete Lifting
Concrete lifting raises sunken driveways, patios, and garage floors with foam or mudjacking. Free estimates, no tear-out required.
Concrete Leveling
Concrete leveling in Garland, TX corrects uneven slab sections and joint offsets with foam or slurry injection. Free estimates.
Mudjacking
Mudjacking in Garland, TX raises sunken driveways and patios with cement-based slurry injection. Free estimates.
Ask about Driveway Leveling
Tell us about the project and how to reach you.